Here's a gift card holder that is quick and beautiful!!
Cut a piece of cardstock 4 1/4" x 8 1/2". Score at 3 1/4", 4 1/4", and 5 1/4".
Fold on score lines so that the cardstock forms a "W" shape.
Fold over on the 4 1/4" score line and with the Stitched Rectangle die measuring 3 1/2" (available Jan 3rd for customers) cut a partial rectangle shape out of the center of the card stock. Be sure to have a border around all three sides of the rectangle - make sure your die does not cross the score line.
Using Tombo and Tear and Tape, adhere as shown below. Be careful to only put small dots of Tombo right at the score line so that there is a slot for the card to sit in.
And here is the basic card holder! Now to decorate it, use pieces of Designer Series Paper (DSP) of your choice. In my example above I adhered one 3" x 4" rectangle inside (leaving one side free for stamping and your signature) and two 3" x 4" rectangles on the outside of the card holder. To finish, tie an approximately 16" piece of ribbon around the outside.